Panasonic CT-3268S - Manual (Page 17)

Recall Button
Press the RECALL button to review:
0 Audio Mode status
(|) CH number or Video Input selected
@ Channel Caption (Station Identifier)
® Clock time
(5) Sleep Timer status
Special Functions
© ©
©
R-Tune Button
Pressing the R-TUNE (RAPID TUNE) button will switch
between the last two channels selected on the numeric
keypad.
Note: When scanning channels with the CHANNEL
UP/DOWN button, pressing the R-TUNE button
will switch between the last two channels
scanned.
.CHANNEL NOW
’ BEING VIEWED
CHANNELTUNED
IMMEDIATELY BEFORE
Press Button
Press Button Again
The MULTI button can be programmed to operate up
to six (6) Remote function buttons at the same time.
For Example: TV Power/On, VCR Power/Oh, and Cable
box Power/On (selected brands) can be operated at thè
same time with one press of the MULTI button.
(The VCR
Mode button should be programmed before starting
procedure).
Procedure
1. Program the Remote for the selected device Infrared
access code. Confirm that the Remote Control is
compatible with the device.
2. Face the Remote Control transmitter away from all
equipment remote sensors.
3. Press and hold the Remote POWER button, then
press and hold the ACTION button down at the same
time for three seconds. (Air previous commands are
erased.)
Multi Button (for CT-32S21)
PRESS AT THE SAME TIME FOF
THREE SECONDS
4.
5.
6
.
After three seconds, release the POWER and
ACTION buttons.
Press the MULTI button.' (Waiting more than 30
seconds without pressing another button will exit the
programming mode.)
Press a maximum of six (6) function buttons on the
, Remote Control.
Each button you press is equal to one function. If six
(6) Remote button functions are entered, all will
register in the MULTI button memory in the sequence
entered. When finished, press the MULTI button to
exit the programming mode.
The following is an example flow chart of Remote
functions that can be programmed into the MULTI
button.
You can now turn the TV and VCR ON/OFF at the
same time with one press of the MULTI button.
To delete entered functions - Press and hold the
Remote POWER button, then press and hold the
ACTION button down at the same time for three
seconds. You can now enter from one to six different
Remote functions.
NOTE: You can also program the MULTI button to perform
most individual Remote Control button functions.
Buttons which continuously perform a function as
long as pressed (Volume Up/Down, Channel
Up/Down, etc.) cannot be programmed; only those
buttons which perform a function when initially
pressed (Power On/Off, Mute, Direct Channel
Entry, etc.) can be programmed.
- 1 7 -