Yamaha MC1602 - Manual (Page 15)

SPECIFICATIONS
I
Total Harmonic
Distortion
Less than 0.1%, 20Hz - 20kHz @ +14dB
into 600 ohms.
Frequency Response +1,-3dB, 20Hz - 20kHz (3)+4dB into
600 ohms
Phantom Power
+48 VDC applied to electronically balanced inputs via 6.8 k-ohm
limiting resistors. Master ON/OFF switch.
Hum and Noise* (20Hz —128dB
— 20kHz, Rs=150 ohms, —90dB
Input Gain max.. Input
Pad @ OdB, Input —73dB
Sensitivity —60dB)
-64dB
-70dB
-64dB
equivalent input noise,
residual output noise (balanced
outputs).
at STEREO OUT with master
fader at nominal level and all
channel faders at minimum level,
at STEREO OUT with master
fader and one channel fader at
nominal level
at AUX SEND with AUX SEND
level control at nominal level
and all channel AUX controls at
minimum level.
at AUX SEND with AUX SEND
and one AUX control at nominal
level.
Power Requirements
U.S. & Canadian models: 120V AC, 60Hz
General model:
110 - 120/220 -240V AC, 50/60Hz
Power Consumption MCI 602:
MCI 202:
MC802: 60 watts
50 watts
40 watts
Dimensions (W x H x D)
MCI 602: 730 mm X 151 mm X 531 mm
(28-3/4" X 6" X 20-7/8")
MCI 202: 590 mm X 151 mm X 531 mm
(23-1/4" X 6" X 20-7/8")
MC802: 450 mm X 151 mm X 531 mm
(17-3/4" X 6" X 20-7/8")
Weight MC1602: 18 kg. (39.7 lbs.)
MCI202: 15 kg. (33.1 lbs.)
MC802: 12 kg. (26.4 lbs.)
Maximum Voitage Gain 84dB
84dB
94dB
20dB
lOdB
CH IN to STEREO OUT
CH IN to AUX SEND 1
CH IN to AUX SEND 2,3
AUX RETURN 1,2 to STEREO OUT
SUB IN to AUX SEND 1 - 3
• Measured with a —6dB/octave LPF (s> 12.7kHz.
• OdB = 0.775Vr.m.s.
• Specifications subject to change without notice.
lOdB SUB IN to STEREO OUT
Input Channel Gain Control
—20~—60dB variation in gain, stop to stop.
Input Channel Pad Switch
0/20dB of attenuation.
Input Channel Equalization
15dB maximum boost or cut in each of three bands.
HIGH: 10kHz (shelving)
MID: 350Hz - 5kHz (peaking)
LOW: 100Hz (shelving)
Crosstalk -60dB at 1 kHz, adjacent input channels.
-60dB at 1 kHz, input to output.
VU Meters (0 VU = +4dB Output)
3 iliuminated meters.
STEREO L, STEREO R, AUX 1/AUX 2/AUX 3/CUE (switchable)
Clip Indicators
RED LED built into each input channel. Lights when post-EQ
channel signal is 3dB below clipping level.
14