Rack mounting for portability, Positioning the mixer housing, Positioning rubber feet – Yamaha EM1620 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

RACK MOUNTING FOR PORTABILITY

POSITIONING THE MIXER HOUSING

The unit is cooled by means of a compulsory Tan located

in the rear panel. Because the fan intakes cool air through^

the rear panel and exhausts warm air out of the side pan

els, portable racks must be designed to ensure that proper
air flow is maintained. The figures below show an ex
ample of a well-ventilated rack: The rear panel is com

pletely open and the side panels are exposed where nec

essary. Refer to the dimensions (page 14) for correct po

sitioning of the rack exhaust holes.

Place the case so that the ventilation airflow paths are

not blocked.

(Side View)

Front

Air intake

less than 10 cm

Front

POSITIONING RUBBER FEET

Keep both side panels exposed for air exhaust.

Rubber feet are optional items.

Peel the backing off of the rubber foot and stick to the

bottom of the mixer. The figure below indicates the best

positions for optimal stability.

(Rear View)

*40mm= 1-9/16"

unit: mm