Panasonic KX-TG9150E - Manual (Page 32)

Useful Information Useful Information
mot send or receive SMS
messages.
Cause & solution
• You have not subscribed to the appropriate service.
Consult your service provider/telephone company.
• The SMS message centre number(s) are not stored
or are incorrect. Store the correct numbers (page
40),
• Message transmission was interrupted. Wait until
the message has been sent before using other
telephone functions.
• Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
The SMS message centre number
is togged in the caller list but a
message was not received.
• Someone tried to send you a message while SMS
was turned off.
“FD” is displayed. • The unit could not connect to the SMS message
centre. Confirm that the correct SMS message
centre numbers are stored (page 40). Confirm that
SMS is turned on (page 40).
“FE” is displayed. ® An error occurred while sending the message. Try
again.
“EO” is displayed. • Your phone number is permanently withheld or you
have not subscribed to the appropriate service.
Consult your service provider/telephone company.
‘V” is not displayed after 1 read a
message. * When an error code (“ fd ”, “ fe ", or “EO”) is
displayed, ‘V” will not be displayed even if you
have read the message.
The unit does not record new
messages.
• The answering system is turned off. Turn it on (page
45),
• The recording time is set to “Greeting Only”.
Select “1 Minute” or “3 Minutes” (page 49).
• If you subscribe to the voice mail service,
messages are recorded by your service
provider/telephone company not your telephone.
Change the unit’s
“Mumber of Rings” setting so
that the unit's answering system can answer the
call before the voice mail service or consult your
service provider/telephone company (page 49).
The other party complains that they
cannot leave a message. • The recording time is set to “Greeting Only”.
Select “1 Minute” or “3 Minutes” (page 49).
1 cannot operate the answering
system with the handset.
• The base unit or another handset is being used.
Wait for the other user to finish.
• A caller is leaving a message. Wait for the caller to
finish.
• The handset is too far from the base unit. Move
closer.
When 1 try to operate the
answering system with the base
unit, [®] flashes for a few
seconds and 1 cannot operate the
answering system. • Another handset is being used. Wait for the other
user to finish,
• A caller is leaving a message. Wait for the caller to
finish.
1 cannot operate the answering
system remotely.
• You are entering the wrong remote access code. If
you forget the remote access code, store a new
remote access code and try again (page 47).
• You are pressing the dial keys too quickly. Press
each key firmly.
• The answering system is turned off. Turn it on (page
48).
• You are using a pulse telephone. Try again using a
touch tone phone.
While recording a greeting
message or listening to messages,
the unit rings and recording stops. ® A call is being received. Answer the call and try
again later.
62 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333 Helpline Tel. No.: U.K. 08700 100 076 R.O.I, 01289 8333 63