Panasonic LUMIX DMW-FL360 - Manual (Page 22)

Press the [MODE] button, and
select the flash mode. (P19)
® The flash working range is
shown on the display panel in
line with the settings of the
digital camera
n n
u.u
2 Press the shutter button
all the way down, and
take the picture.
3 Check that the [AUTO
CHECK] lamp is flashing.
1 1
i
..... """ ^
X
!
AUTO CHECK
O Z*
!
llllll
®
®: Flash working range
• If the settings on the digital
camera (ISO sensitivity and
aperture) are outside the
combinations of the ISO
sensitivity and aperture which
can be adjusted, the flash
working range is not displayed
and the user is warned by the
flashing of [ISO] and [F] on the
display. In a case like this,
change the digital camera
settings.
1 Check that the distance
to the subject is within
the flash working range.
® If the subject is outside the
range, adjust the aperture of the
lens or change the distance to
the subject.
• The flash working range
changes depending on the type
and settings (ISO sensitivity,
aperture and focal length) of the
digital camera used.
If the [AUTO CHECK] lamp
continues to flash for about
5 seconds, it means that the unit
has fired successfully. If it does
not flash, the unit has not fired
successfully. Check the settings
on the unit and the digital
camera and then take the
picture again.
I
Combinations of the ISO
sensitivity and aperture which
can be adjusted in the [AUTO]
mode
22
VQT1B10
ISO sensitivity Aperture
3200 F8 to F32
1600 F5.6 to F32
800 F4 to F32
400 F2.8 to F32
200 F2 to F32
100 FI .4 to F22
50 FI .4 to F16
25 FI .4 to F11