3 check that the [auto check] lamp is flashing – Panasonic LUMIX DMW-FL360 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

*ress the [MODE] button, and

elect the flash mode. (P19)

> The flash working range is

shown on the display panel in

line with the settings of the

digital camera.

3 Check that the [AUTO

CHECK] lamp is flashing.

AUTO CHECK

i n

: >

iLLL. :

Flash working range

I Check that the distance

to the subject is within
the flash working range.

> If the subject is outside the

range, adjust the aperture of the
lens or change the distance to

the subject.

^ The flash working range

changes depending on the type

and settings (ISO sensitivity,

aperture and focal length) of the

digital camera used.

Press the shutter button

all the way down, and

take the picture.

® If the [AUTO CHECK] lamp

continues to flash for about
5 seconds, it means that the unit
has fired successfully. If it does
not flash, the unit has not fired

successfully. Check the settings
on the unit and the digital
camera and then take the

picture again.

VQT1B10