Panasonic PV C2063 - Manual (Page 23)

ine remoie and try the Dutton again.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few
seconds to cancel the Timer
Recording.
• Any future daily or weekly recordings
will be performed as programmed.
SELECT/SET
CH UP
CH DOWN
VOL UP
VOL DOWN
■PROG
- ADD/DLT
-STOP
Review, Replace or Clear Program
Contents : (Recording is not in progress)
1 Repeat steps 1 and 2 on page 22.
..ii; tü:üüal.2i
4
.R., .
?)
6ЦЬ..1.Ь SH
>OAf>iCEt;'ADD№-fi-- :-''-
Press
AT
to select the
desired program.
To Replace program...
8 SAT 9:OOP12:OOA08
, .:.•••-TPLy:-:
::.-$EL!"C:i'-:A:-T oyW/RFF
.•HNö- •••■'VPROQ :•
1) Press ► to display.
2 )
Press AT
to select
and
press -4 or ►
to set new program
contents.
3) Press PROG.
To Clear program...
OR-;;
D;i^i-viD:v;sn».:;
4,:-S.U -y ,ß,:.papiö:rJUp
bANCEL': AEÖ/bÜf .
■.■.■.:§EI£CT::.A t .T:.:.:':
’ END T. -iPROQ::
Press PROG twice to exit this mode.
' 2 minutes before Timer recording is performed, “PLEASE
PREPARE FOR TIMER REC" appears and/or the PROG
TIMER indicator flashes. Be sure a cassette with record tab is
loaded and the unit is in Stop mode.
If the start times of two programs overlap, the lower numbered
program will have priority.
If the start time for a Timer Recording comes up during a
normal recording or One Touch Recording {page 12}, the Timer
Recording wilf not be performed.
If there is a power interruption ot more than one minute, the
recording may not be performed or continued.
If “INCOMPLETE" appears after all items have been set, check
all entries and make necessary corrections.
23