Panasonic LF-1004AB - Manual (Page 24)

Before Operation
This drive conforms to the SCSI standard. A SCSI host adapter is therefore required to connect the
drive with a personal computer.
SCSI: an acronym for “Small Computer System Interface”. This is a standard that governs connec­
tions between personal computers and peripheral devices.
NOTE:
No more than 7 SCSI units can be connected to a computer. Also, the total length of the SCSI cable
from the personal computer to the last unit MUST NOT exceed 6 meters.
/W\ /W\ /W\ /W\ /W\
Terminating unit SCSI cable
Personal computer
• (A) through (G) are SCSI units.
Terminating unit
Installing the SCSI Host Adapter
The drive must be connected to a SCSI host adapter. If the SCSI host adapter is not installed inside
your personal computer, you must install it by following the instructions that accompany the adapter.
After completing the connections, check that the personal computer starts up properly.
Recommended SCSI host adapters (for desktop personal computers):
• Macintosh series: already installed
• IBM PC/AT or compatible: Adaptec
AVA-1505, AHA-151x, AHA-152x, AHA-154x,
AHA-164X
Always AL-500
BusLogic BT545
Future Domain TMC-1650MCD, TMC-850
CorelSCSI for PD, the Device Driver software included with the PD/CD-ROM Drive includes an ASPI
manager and supports the host adapters listed above. If a host adapter not listed above is installed,
a separate ASPI manager program may be required.
- 24 -