Panasonic PanaSync S110 - Manual (Page 19)

< Onscreen Display> < Function and Operation>
Language selection
L a n g u a g e
DEU F R A lagia
ITA ESP
The language used by the On-Screen Display
can be selected with the "3" and "B" keys from
among German, French, English, Italian and
Spanish.
DEU: German
FRA: French
ENG: English
ITA : Italian
ESP: Spanish
gig OSD Position
« t
I I**! I*»! I
It is possible to adjust the position that the on­
screen Menu is to be displayed.
The Menu will rotate in a counter-clockwise
direction every time the [H key is pressed.
^ Degauss
Degaussing operation can be selected.
After this is selected, the degaussing action takes place for approximately 6 seconds.
Key operation is not possible while demagnetization is performed.
o Signal (Input Port)
1280
X
1024
fH 63.7kHz
fV 60.1 Hz
P o r t
This displays the input synchronization signal
frequency.
Information on the input screen mode {resolution,
horizontal and vertical synchronization frequency)
wilt be displayed on the display monitor. There
are occasions sometimes when some screen
modes in use do not display any resolution. Direct
operations allow this to be displayed on screen by
pressing the H] key even when the menu screen
is not displayed.
Use the 3 or B key to select either the rear
panel input terminal port A (Mini D-Sub type) or
port B {BNC type).
Csution: When power management Is in effect
on either port A or port B, the input cannot be
switched from one to the other.
Release the power management before switching
the terminal selection. See page 14.
“How to release the system from the Power
Management Function,’’
- 1 3
-