Panasonic KX TC1503B - Manual (Page 50)

^ Before Requesting Help
General
Problem Cause and Remedy
The unit does not work. •Check the settings (p. 10-14).
•Charge the battery fully (p. 11).
•Clean the charge contacts and charge
again (p. 11).
• Install the battery properly (p. 44).
• Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in
and try again.
• Re-insert the handset battery within
3 minutes to avoid loss of memory and
place the handset on the base unit. Try
again.
I
You cannot program items j »Programming is not possible while the
such as the dialing mode 1 unit is in the talk or intercom mode, or
(p. 12) or the day/time i while the answering system is in use.
adjustment etc (p. 18). i »Move closer to the base unit.
! »Do not pause for over 60 seconds
j while programming.
Previously programmed
information is erased.
• If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
The RECHARGE indicator
flashes or the unit beeps
intermittently.
•Charge the battery fully {p. 11).
You charged the battery
fully, but the RECHARGE
indicator flashes.
•Clean the charge contacts and charge
again (p. 11).
• Install a new battery (p. 44).
The IN USE/CHARGE/
HOLD indicator light does
not go out while charging.
•This is normal.
50