Panasonic KX TC1503B - Manual (Page 49)

Answering System
Problem Cause and Remedy
The answering system is on,
but incoming messages are
not recorded.
•The recording time is set to “greeting
only”. Select “1 minute” or “3 minutes”
(p. 19).
• Memory is full. Erase some, or all, of
the messages {p. 33).
You cannot listen to the
recorded messages.
•Make sure that the unit is in the
standby mode.
“ ВДД” is displayed and the
ANSWER ON indicator
flashes rapidly, and no new
messages are recorded.
•Memory is full. Erase some, or all, of
the messages (p. 33).
You cannot operate the
answering system at the
base unit.
•The handset user is operating the
answering system, or is engaged in an
outside call. Wait until the IN USE/
CHARGE/HOLD indicator light goes
out.
You cannot operate the
' answering system from a
touch tone phone.
• Make sure you enter the correct remote
code.
•The answering system may not respond
if the tones are too short to activate the
unit. Press each button firmly.
•The answering system is off. Turn it on
{p. 39).
You cannot operate the
answering system with the
handset.
1
•Someone is operating the answering
system.
•You are too far from the base unit.
Move closer to the base unit.
•The unit is recording a message. To
answer the call, press Si or S} •
While recording a greeting
message, the unit starts to
ring and stops recording.
•To answer the call, lift the handset off
the base unit or press Si or Kl •
Start again from the beginning after
hanging up.
i3
During playback, the unit
starts to ring and stops
playback.
►To answer the call, lift the handset off
the base unit or press (3 or . To
resume playback, press
[NEW MESSAGE/SLOW TAU^ after
hanging up.
49