Panasonic OMNIVISION VHS PV-M2767 - Manual (Page 10)

On Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the channel
number will appear for a
few seconds on-screen.
(Some station names may
also appear.)
When a function button is
pushed (PLAY, FF, etc.), the
Combination VCR mode will
be displayed.
• When a recording is started, both REC and
the channel number will appear together.
Menu Screen
1 Push MENU to display
the MAIN MENU.
2 Push ^00 and
MENU to make your
selection (see page 8).
To get the most from
each feature, please read the
Operation Manual before
attempting any operation.
Warning and Instruction Displays
These displays will alert you of a missed operation or provide
further instructions.
If no active channels are found
for CHANNEL MEMORY...
(see page 5.)
If you attempt to set or
review a Timer Recording
or set the On Timer and
the Clock is not set...
(see pages 8, 9.)
If a Timer Program was not
completed before exiting the
Program mode...
(see pages 18, 19.)
If you push REC on the
remote control or the
Combination VCR, and a
cassette is inserted with no
record tab...
(see page 29.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
[ date START STOP C h ]
7 SUN 10:30P10:30P125
1________________________ SLP|
SET :■< ► KEY
END :PROG KEV
CHECK CASSETTE
RECORD TAB
VCR Status & Clock Display
ilSPLA>
□
I I Push DISPLAY to display and remove
i
PJ splay I the overlay shown below.
Function Status Current Time
Rec Time
Remaining
(OTR mode only
see page 17.)
Receivable
Broadcast Types
(See page 22.)
REC 12:00AM «NET - i о
" 0 : 2 5 0:00:00 oridniiei Ot
idSTEHEO 1 SLP
frSAP
MONO
Call Letter
Tape Speed
Tape Counter
Blank Tape/ No Video Signal Indication
When a blank section of tape comes up in Play
mode, or the selected channel has no broadcast
signal, the TV screen will turn solid blue.
If you push STOP during a
Timer Recording...
(see page 19.)
If you push PLAY, FF, REW, or
REC on the remote control or
the Combination VCR without a
cassette inserted...
(see pages 16, 17, 24.)
If Combination VCR is not in
Stop mode or a cassette with
record tab is not inserted two
minutes before a Timer
Recording is about to begin...
(see pages 18, 19.)
If head cleaning becomes
necessary while playing
back a tape...
(see page 29.)
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
PLEASE PREPARE
FOR TIMER REC
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
10
If you push a function button
other than STOP/EJECT or
POWER while the
Combination VCR is in VCR
Lock mode...
(See page 20.)