Playing mpeg 2 multi-channel audio – Panasonic DVD-A360A User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Initial settings
D«Lay time [only for Dolby Dlgllal (AC-3) discs] (Q):
(f the surround spsakere or the centre speaker can'l be
Installed at er equal distance to the front speakers frcin
the listaning position, change the delay time to get better
surround effect,
•When D2 or D3 Is equal to or larger than D1, no setting is
necessary. Othervrfee, change the setting according to
the table below.
Speaker
Difference between 01
and D2/D3
Delay time
Centre
speaker
(D2)
approx, 50 cm
approx. 1 DO cm
approx. 150 cm
approx, 200 cm
1.3 ms
2 6 rris
3,9 ms
5.3 ms
Surmiund
speakers
(D3)
approx. 200 cm
approx. 400 cm
approx. 600 cm
S,3ms
10,6 ms
15,9 ms
To adjust the channel balarK« using the test signal
1. Select Tesf with the Joystick (A, T, ►), and then
press SELECT.
(Test signals wilt be output clockwise from each speak
er except the subwoofer consecutively.)
2. While listening to the lest signalr tilt the joystick
(A, ▼) to adjust the volume of each speaker until (he
test signal Is heard at a similar level from ^1 speakers.
3. Press SELECT. (The test signals are stopped.)
FRONT (L)-»-CEPiTRE^FRONT (R)
t
4-
SUHHOUND (L)v----SURROUND (R)
Note
•Test signal le not output from the subwoofer. Subwoofer
volume should be adjusted to suit Ihe material being
l^ayed.
4
Tilt the joystick (A, T, to Beleot
"Exit” and press SELECT.
Setting Is finished and the initiaL settir>gs screen is displayed.
Playing MPEG 2 multi-channel audio
MPEG
2
mulb-chanoel audio is output from the 5.1 channel
output connectors
(
0
)
if you have set Ihe oenire, surround and
subwoofer Speakers to "/es" in "6 Speaker Setting'’, just as
with Dolby Digital and dts. If you are using 2 channel audio
output connectors (Q), the digital audio output conrtectcrs
(when PCM* Is selected in '4 MPEQ" in the digital audio
output settings on page 35) (0)i oi the phones jack, however,
then only the signals for the front speaker channels are output.
If you intend to use cne of these types of terminals, go to
“8 Speaker Setting" and set the centre, surround, and sub
woofer channels to “No".
38
t':'