Panasonic QTR 2140 - Manual (Page 10)

USER'S MANUAL
When using a HD monitor, which supports Y/Pb/Pr or R/G/B/HS/VS component video
input, you should turn the mode selection switches to AA. AB or BB. it depends on
which resolution your HD monitor can support.
When using a conventional TV, which supports Y/Pb/Pr, S-Video component video
input or CVBS composite video input, you should turn the mode selection switches to
BA.
If you use a Monitor or plasma display, turn the mode selection switch AA. AB or BB.
5 Operating Instructions: Knowing your basic controls
To become acquainted with the operations and functions of your receiver, you must
know how to use the control buttons on the Front Panel and the Remote Control.
The following segment is an introduction to features that you will most commonly
notice or use.
5.1 Switching On Your Receiver
Before you switch on your receiver please make sure the power mains is
plugged into a power outlet. Remember that as long as the power mains remains
plugged into your receiver, it will be in a constant “STANDBY" mode.
Turn on your TV and other connected audio/video equipment. Switch on your
receiver by pressing either the E button on the remote control or (!) on the front
panel. While the receiver is in normal viewing mode, the green LED lights up.
When not using the receiver, put your equipment in the “STANDBY’ mode by
pressing either one of the IS / O buttons again. When the red “STANDBY"
LED lights up, it indicates the receiver is in “STANDBY’ mode. The front panel will
show current time.
5.2 Information Plate
The Information Plate (l-Plate) shows
information about the program that you are
currently watching. The information plate
appears shortly, whenever you switch to a
new channel or when there’s problem with
signal reception. To show the information
9
1. FACrS HD Test Service
.'«•0 OhOWJO Uarhmir Swini;
®t>8.‘07
Ei
08t3(M»:00 St-nice 2