Dynon Avionics EFIS-D10A Installation Guide - Manual (Page 94)

Appendix
* If an HS34 failure is detected during this condition, the EFIS “direct” audio output (tones only
is automatically re-enabled (fail-over).
Selecting TES )
T VOICE OUTPUT and then pressing SEL► produces an audible voice test
ns and
volum
The possible voice alerts for both EFIS and EMS are listed i
d BARO settings P >
uire an init ny
is configured by setting FIRST ACTION: ALT /
e, respectively.
b activates r BARO)
ow indicati he
b within 5 seconds changes the value RO).
within 5 seconds a de-activates
up win
UE kn s out)
up
h of the VALUE knob, the e
tivates
e pop-up windo
a third time or after a knob rotation (within the 5 second
es the VA ow.
he value of the FIRST ACTION mode (ALT or
w indicati
nds of the last knob rotation closes the pop-up
(“DYNON AVIONICS”) on the audio output line. This allows you to verify connectio
e on the ground.
n the table above.
VALUE Knob Configuration
The VALUE knob changes the ALT an
VALUE KNOB ►.
The VALUE knob can be configured to req
effect (REQUIRE PUSH: YES / NO).
The “default” mode of the VALUE knob
BARO to set Altimeter or Barometer mod
If REQUIRE PUSH is set to YES:
 The first push of the VALUE kno
and displays a “pop-up” wind
kno
and is configured from HSI SETU
ial push before rotating the knob has a
the FIRST ACTION mode (ALT o
ent mode and value. Rotatin ng the curr g t
of the FIRST ACTION mode (ALT or BA
A second push of the VALUE knob
the VALUE knob and closes the pop-
knob push or knob rotation), the VAL
after 5 seconds and closes the pop-
 If, after the first pus
fter rotating the knob
dow. If there is no further action (either a
ob automatically de-activates (time
window.
knob is not rotated, a second push of th
VALUE knob within 5 seconds ac
indicated by the mode displayed in th
 Pushing the VALUE knob
windows described above) de-activat
If REQUIRE PUSH is set to NO:
the secondary mode of the VALUE knob –
w.
LUE knob and closes the pop-up wind
 Rotating the VALUE knob changes t
BARO) and displays a pop-up windo
the VALUE knob again within 5 seco
window. ng the current mode and value. Pushing
 Pushing the VALUE knob without first rotating it activates the secondary mode of the
VALUE knob (ALT or BARO, whichever was not chosen as FIRST ACTION) and
displays a pop-up window indicating the current mode and value. Pushing the VALUE
knob again within 5 seconds of the last knob rotation closes the pop-up window.
 If there is no further action (either a knob push or knob rotation) within 5 seconds, the
pop-up window automatically closes.
7-22 EFIS-D10A Installation Guide