DVR systems DVR-HDE-960H-960H2 Series - Manual (Page 124)

9.2.4 Configuring SNMP
Purpose:
You can use SNMP protocol to get device status and parameters related information.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the SNMP tab to enter the SNMP Settings interface.
Figure 9.14 SNMP Settings Interface
3. Check the SNMP checkbox to enable this feature.
4. Configure the SNMP settings.
Figure 9.15 Configure SNMP Settings
5. Click the Apply button to save and exit the interface.
Note: Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the device is allowed to send the alarm event and
exception message to the surveillance center.
9.2.5 Configuring UPnP
™
Purpose:
UPnP™ can permits the device seamlessly discover the presence of other network devices on the network and
establish functional network services for data sharing, communications, etc. If you want to use the UPnP™
function to enable the fast connection of the device to the WAN via a router, you should configure the UPnP™
parameters of the device.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of the router
to which your device is connected. When the network working mode of the device is set as multi-address, the
123