CANOGA PERKINS L357 Gigabit Ethernet Service Unit - Manual (Page 37)

EdgeAccess Universal Chassis System
System Information - Local Unit
1. System Name :
2. Contact :
3. Location :
4. Customer :
5. Information :
:
6. Circuits :
:
7. Service Code :
8. Date-in-Service :
9. Date-Out-of-Service :
10. Equipment Type :
11. Equipment Code :
12. Vendor :
13. CLEI :
14. Mfg Date :
15. Unit :
Figure 27. System Information Screen
4.6 Diagnostics Screen and Loopback
Use the Diagnostics menu for troubleshooting the L357; you can view current loopback conditions
and set up loopback. See Figure 28.
DIAGNOSTICS
1) Loopback Setup
Figure 28. Diagnostics Screen
Use the Loopback Setup screen to view current loopback conditions and set up loopback conditions
for troubleshooting the L357. See Figure 29 and Table 9. For details about using loopback, see
Chapter 3. To run a loopback test, follow these steps:
1. From the Main Menu, type 2 , "Diagnostics," and press . The Diagnostics menu appears.
2. From the Diagnostics menu, type 1 , "Loopback Setup," and press . The Loopback Setup
screen appears.
3. Type the number for the loopback option you want to set, press to highlight the Remote
column if needed, press to cycle through the options, and press .
4. When you finish running Loopback, press to return to the Diagnostics menu, then press
to return to the Main Menu
Note: The Model 1030 enclosure does not support loopback options.
L357 Gigabit Ethernet Service Unit 4-17