CANOGA PERKINS L357 Gigabit Ethernet Service Unit - Manual (Page 33)

EdgeAccess Universal Chassis System
The SNMP agent allows access to up to 24 Host IP addresses listed in the Host Table. Set up the
Host information for the L357 on the Host Table screen. See Figure 23. To access the Host Table,
follow these steps:
1. From the SNMP Configuration menu, type 13 , Host Table, and press . The Host Table
screen appears.
2. To add a Host, type 1 and press , or to edit a Host, type 3 and press , then follow
the prompts to enter values to set the access and protocol parameters.
3. To delete a host, type 2 and press , then at the prompt, select the Host.
4. To return to the SNMP Configuration menu, press .
HOST ACCESS TABLE
Managing Host Telnet FTP SNMP SNMP V1/V2c Rd V1/V2c Wr V1/V2c
IP/Mask Bits Access Access Access Protocol Community Community Access
172.016.002.232/32 Yes FTP Write V1/V2c/V3 public netman Superv
172.002.002.232/32 Yes FTP None V1/V2c/V3 public netman Observ
172.016.142.001/32 Yes Both Write V1/V2c/V3 public netman Observ
Figure 23. Host Access Table Screen
The Trap/Notification Destination Table screen lists information about and options to set up hosts to
receive notification of traps and alarms. To access the Trap/Notification Destination Table screen,
see Figure 24 and follow these steps:
1. From the SNMP Configuration menu type 7 , "Trap Table," and press .
2. At the Trap/Notification Destination Table screen, type 1 to edit a host or 2 to add a host at the
Edit Notification Destination Entry screen, or type 3 to remove a host.
Note: To add or edit a host entry, follow the prompts on the notification destination entry screen.
3. To return to the SNMP Configuration menu, press .
TRAP/NOTIFICATION DESTINATION TABLE
Managing Trap Username/ Security
Host Port Type Community Level
172.16.14.200 163 V1-Trap public N/A
172.16.100.20 162 V2c-Trap public N/A
172.16.142.1 163 V3-Trap public Auth/No Priv
Figure 24. Trap/Notification Destination Table Screen
L357 Gigabit Ethernet Service Unit 4-13