CANOGA PERKINS 2345 T3 Fiber Optic Modem - Manual (Page 27)

EdgeAccess Universal Chassis System
Model 2345 User Manual 3-11
Set Up Host Access
The SNMP agent allows access to up to 24 Host IP addresses listed in the Host Access Table. Set up
the Host information for access to the 2345 on the Host Access Table screen. When a host attempts
to access the 2345, the IP address is authenticated against the entries on the host table. If a user
attempts SNMP access from a host or network that is not listed in this table, the 2345 rejects that host
and generates an authentication trap. To access the Host Table, follow these steps:
1. At the SNMP Configuration Parameters menu, type 8, "Host Access Table," and press .
The Host Table screen appears.
2. To add a host, type 1 and press , then follow the prompts to enter values for these
parameters:
a. IP Address: for the Host
b. Access Level: Read, Read/Write Read/Trap, or Read/Write/Trap
c. Trap Community: the community name for requests from the host or network
3. To delete a host, type 2 and press , then at the prompt, type the IP Address for that Host
and press . The host table appears again with your changes.
4. To return to the SNMP Configuration Parameters menu, press .
Change Your Password
You can update your password for the 2345 in order to maintain security. You cannot change the
password for any other users, especially those who are not logged in. To update your password,
follow these steps:
1. From the Utilities menu, type 2 , "Change Password," and press .
2. To change your password, follow the prompts on the screen.
3. To return to the Main Menu, press .
Manage the Modem
After you set up modem functions, you can monitor those functions and the data transmission.