Manage the 2345, View the hardware setup, Set the date and time – CANOGA PERKINS 2345 T3 Fiber Optic Modem User Manual
Page 21
EdgeAccess Universal Chassis System
Model 2345 User Manual
3-5
Manage the 2345
You can manage the hardware and software for the module, including communication access.
View the Hardware Setup
To view information about the hardware setup, including model and serial numbers, as well as view
basic system information for both the local and remote 2345s, go to the Hardware Configuration
report. See Table 5. To access the System Configuration screen, follow these steps:
1. At the Main Menu, type 1, "System Configuration," and press
Configuration screen appears.
2. At the prompt, type 1, "Hardware Configuration," and press
Configuration screen appears.
3. To return to the System Configuration menu, press
Table 5. Hardware Configuration Report
Item Shows
Chassis/Slot
Where the modem is installed
Modem Model, Type, Revision, Serial No.
Data for the modem
OLIM Model, Type, Revision, Serial No.
Data for the optical interface
Power Supply Pri, Sec
Type(s) and status for the power supply(s)
Fan Installed
Status if a fan is installed
SNMP Management
If SNMP is enabled or disabled
Set the Date and Time
An accurate date and time assures accuracy for traps and alarms sent to the system administrator, as
well as for all listed events. If the 2345 is in a system with a DMM, the date and time for the DMM
overrides any date and time set in the 2345.
To set the date and time, follow these steps:
1. At the Main Menu, type
6
, "Utilities," and press
2. At the Utilities menu, type
1
, "Set Date and Time," and press
the current date and time, type the current information in
DD/MM/YYYY HH:MM
format.
3. To return to the Main Menu, press
Note: Because the Clock circuit exerts a large power drain on the battery in the 2345, the Clock
may lose time when the power is off or the 2345 is out of the chassis. Reset the date and time
whenever you install the 2345 in the chassis or turn the power on.