CANOGA PERKINS 3240S SNMP-Managed T1/E1 Fiber-Optic Multiplexer - Manual (Page 15)

EdgeAccess
3240S Fiber-Optic Multiplexer 2-3
E1X, 3-Port I/O Card
The E1X card supports three channels and either High Density Binary Three (HDB3) or AMI line
coding, uses two time slots, and uses one physical slot in the chassis. The E1X card includes three
connectors, either 75 ohm BNC or DA-15, configured as DCE. Chapter 5 lists all connector pin
assignments. To set up the E1X card, see Figure 6 and follow these steps:
1. Set the time slot at jumper W3. Both ends of each link must be set to the same time slot. Install
the jumper for time slots 1 and 3. Remove the jumper for time slots 2 and 4.
2. Jumpers W4, W5, and W6 control the line coding for the ports:
• Port 1: W4
• Port 2: W5
• Port 3: W6
Both ends of each link must be set to the same line coding. For HDB3, install the jumper. For
AMI, remove the jumper. If you will control the line coding through the software, install the
jumper.
Figure 6. E1X I/O Card