Warpia SWP200 Windows Installation Manual & Troubleshooting Guide - Manual (Page 37)

Wireless USB DisplayDock Set User Guide
Page 37
Appendix B: Pairing Procedure
The PC Adapter and Device Adapter in this set are already paired and do not require
performing a pairing procedure. If you should need to perform pairing manually for any
reason (e.g. connecting to a new host PC Adapter, or adding a Device Adapter that was not
purchased in a set), please follow these steps:
To perform Pairing:
1. Ensure that a Wireless USB Host or PC Adapter is connected to the PC.
2. Remove the Device Adapter from the Docking Base and connect it directly to the host PC
USB port, do not use the Docking Base or any other accessory to connect to the PC.
3. Upon first time connection of a Device Adapter to the PC, the Pairing driver is installed
automatically.
4. Once the Pairing driver is installed, pairing is automatically performed between the host
PC and the Device Adapter, and the following confirmation message is displayed: