Sangean DCR-9+ (V1) - Manual (Page 6)

5
Using the clock radio for the first time
1. Place your clock radio on a flat surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
clock radio. Plug the adaptor into a standard 13 amp mains
socket outlet.
4. Press On/Standby button to switch on your clock radio, display will
show “Welcome to Digital Radio“ for a few seconds and start to scan
the DAB+ band and display will show Scanning.
5. The radio will stop and play at first station it finds in the list of
stations during scanning.
6. The clock will be auto adjusted by the DAB station you tune to or you
may refer to “Setting the clock manually“ described later for
clock setting.
Important:
The mains adaptor is used as the means of connecting the clock radio
to the mains supply. The mains socket used for the clock radio must
remain accessible during normal use. In order to disconnect the clock
radio from the mains completely, the adaptor should be removed from
the mains socket outlet completely.
Characters appearing on the LCD display indicate that the radio is
connected to and powered from the mains supply.
Selecting a station – DAB
1. Press the On/Standby button to switch on your clock radio,
the display will show last station you tuned to.
2. Press either Tuning Up or Tuning Down button to enter Station List.
3. Press either Tuning Up or Tuning Down button again to step through
the list of available stations.
4. When desired station appears on the display, press the Select button
to select the station. The radio will tune to the selected station and
display will show the station name and information.
5. Adjust the Volume control to the required setting.
Note:
If after selecting a station, the display shows “not available“, it may be
necessary to relocate your radio to a position giving better reception.