Sangean DCR-9+ (V1) - Manual (Page 10)

9
Presetting stations
You may store your preferred DAB+ and FM radio stations to the preset
station memories. There are 10 memory presets in your radio, 5 for
DAB+ and 5 for FM.
The procedures for setting presets and using them to tune stations is
the same for FM and DAB+ modes and is described as below.
1. With radio switched on, tune to the required station as
previously described.
2. Press and hold down the required preset button until the display
shows e.g. “Preset 1 stored“. The current tuned station will be stored
under the chosen preset button. Repeat this procedure for the
remaining presets as needed.
3. Stations which have been stored in preset memories may be over
written by following the above procedures.
Recalling a preset station
1. With radio switched on, press the Band button to select the
desired waveband.
2. Momentarily press the required Preset button, your clock radio will
tune to the station stored in the preset memory.
Scan sensitivity setting – FM
Your radio will normally scan for FM broadcasts which are strong
enough to give good reception. However, you may wish the Scan
function to also be able to find weaker signals, possible from more
distant radio transmitters. Your radio includes a local/distant option for
the Scan function in the FM band.
1. Switch on your radio and select FM band by pressing Band button.
2. Press and hold INFO button for 2 seconds to enter Advanced mode,
display will show FM Scan Zone.
3. Press Select button to enter FM Scan Zone set.
4. Press Tuning Up/Down button to switch between Local and
Distant options. The distant option will allow the radio to find weaker
signals when scanning.
5. Press the Select button to confirm your selection. The Local or
Distant setting is stored in the radio and remains in force until
changed or until a System Reset.
Note:
The initial setting causes the radio to ignore weak (distant) signals.