Sangean DCR-9+ (V1) - Manual (Page 14)

13
Setting the clock manually
Normally your clock radio will set its clock automatically via the
DAB+ signal. If no DAB+ signal is available and you need to set the
time manually, please follow the procedures shown below.
Note:
The DAB+ signal will always override any manual time setting.
1. To set the clock time manually, press the On/Standby button to
switch on the clock radio.
2. Press and hold INFO button for 2 seconds to enter Advanced mode.
3. Press and release Tuning Up or Down button to allocate System.
4. Press Select button and then Tuning up or Down button to
allocate Time.
5. Press Select button to enter 12/24 hour format setting.
6. Press Select button and Tuning Up/Down button to select 12 hour or
24 hour format . Press Select button to confirm hour format.
7. Press Tuning Up button to enter Set Time/Date mode. Display will
show Time Set and flashes hour digit.
8. Press either Tuning Up or Down button to set hour and confirm the
hour setting by pressing Select button. Display will flash minute,
following above procedures to set minute and confirm the minute
setting by pressing Select button. Display will show Set Date.
9. Following above procedures to set date, month and year. Confirm the
setting by pressing Select button. Display will show “Time Saved“.
10. Press and release INFO button to return to normal radio mode.
Auto clock set mode
1. When radio is switched on, press and hold INFO button for
2 seconds to enter Advanced mode.
2. Press and release Tuning Up/Down button to allocate Time mode.
3. Press Select button and then Tuning Up/Down button to allocate
“Auto Update”.
4. Press Select button to enter Auto Update mode.
5. Press Tuning Up/Down button to select from Update from DAB,
Update from FM and No update. Confirm the setting by pressing
Select button.
Note:
If you select either Update from DAB or FM, the current time will be
displayed after receiving from DAB + station time signal or FM RDS
time signal. If no DAB or FM time signal is found, display will show
“Time not Set“. You should then either position the radio or its aerial so
that a signal can be received or revert to manual clock mode.
Set date format
1. When radio is switched, press and hold INFO button for 2 seconds
to enter Advanced mode.
2. Press and release Tuning Up/Down button to allocate Time mode.
3. Press Select button and then Tuning Up/Down button to allocate Set
Date format.
4. Press Select button and then Tuning Up/Down button again to select
dd(date) – mm(month) – yyyy(Year) or mm(month) – dd(date) –
yyyy (year).
5. Confirm the setting by pressing Select button.