Sangean DCR-9+ (V1) - Manual (Page 15)

14
GB
Factory reset
If your radio fails to operate correctly or some digits on the display are
missing or incomplete, carry out the following procedures.
1. Switch on your radio.
2. Press and hold down the INFO button to enter Advanced mode.
3. Press Tuning Up/Down button to allocate System, press Select
button to enter System.
4. Press Tuning Up/Down button to allocate Factory Reset,
press Select button to enter Factory Reset.
5. Press Tuning Up/Down button to select YES, then press Select
button to start the Reset, display will appear restarting.
6. A full reset will be performed, the station list and presets will
be erased. Display will show “Welcome to Digital Radio“ and then
flash clock digits and Time is not set. You need to start over the
settings again as the time you used the clock radio for the first time.
In case of malfunction due to electrostatic discharge, reset the
product (reconnection of power source may be required) to resume
normal operation.
Auxiliary Input socket ( Aux In socket )
A 3.5 mm stereo Aux In socket is provided on the rear side of your
clock radio to permit an audio signal to be fed into the unit from an
external audio device such as iPod, MP3 or CD player.
1. Plug in the device into Aux In socket using 3.5 mm audio wire
connecting from headphone socket of the device to the
Aux In socket.
2. Press the Band button to AUX IN.
3. Adjust the volume control on your iPod, MP3 or CD player to a
reasonable high level and then adjust the Volume control on your
clock radio for comfortable listening.
Headphone socket
A 3.5 mm Headphone socket located on the rear side of your clock
radio is provided for use with either headphones or an earpiece.
Inserting a plug automatically mutes the internal loudspeaker.
Important:
Excessive sound pressure from earphones and headphones can cause
hearing loss.