Belt Drives Chain Drive - Manual (Page 3)

13. Re-install clutch pack: Two .078” steels first then
alternate clutch fiber and steel ending with a fiber.
Our clutch pack is 8-.078” steels and 7 fibers.
14. Install 9 hole pressure plate, use only 6 springs and shoulder bolts. Tighten bolts until they bottom out, this is
the correct procedure. The other 3 springs and bolts may or may not be needed depending on how much spring
pressure is needed.
15. Adjust clutch with adjusting screw supplied with
kit, to HD specifications. When clutch is adjusted
tighten jam nut to lock screw in place.
16. Install outer primary cover with gasket, tighten all primary cover bolts to HD specifications.
17. Fill primary with ATF type F or whichever lubricant desired. Check HD manual for proper fluid level.
If you have any questions, call 714-693-1313
3