Belt Drives TF-2000 - Manual (Page 4)

FIg. 14
Fig. 15
11. Install starter housing. Be sure starter is aligned properly then bolt
down securely. (Fig. 16)
Fig. 16
12. Install front pulley cover. (Fig. 17)
Fig. 17
13. Install pressure plate along with springs and shoulder bolts.
IMPORTANT- there are 9 springs and bolts supplied with the kit, any
number of springs and bolts can be used from 4 to 9 depending on how
big the motor is and how much spring tension is needed for proper
friction which will vary from bike to bike. (Fig. 18)
Fig. 18
4