V.I.O. POV.1 - Manual (Page 20)

20 POV.1 Recorder
•
•
•
•
•
•
The bottom of the POV.1 with the SD card inserted
Replace the Input/Output Port cover and screw the retaining screw
clockwise until it is tight.
Your POV.1 is now ready for use.
Powering the POV.1
Press the POWER button to start the POV.1. The button only needs to be
pressed briefly, holding it down too long will cause the POV.1 to turn off
again.
The POV.1 is normally powered by 4 AA batteries. The POV.1 can also be
powered by the USB cable when it is connected to a computer. However,
when the POV.1 is being powered by the USB cable it is in USB mode and
can only be accessed from the computer - the controls on the unit itself are
disabled with the exception of the POWER button. Please note that
batteries can not be recharged from the USB power source.