38 adjusting the engine control linkages – OFNA Racing Ultra LX 2 User Manual

Page 22

ASSEMBLY OF THE BRAKE LINKAGE INTO BRAKE LEAVE

94033
M3x3
Set Screw

.....x2

ADJUSTING THE ENGINE CONTROL LINKAGES

Approx. 1mm gap

(Neutral)

(Throttle High)

(Brake)

•Turn on the Transmitter then Receiver and set the
engine Control Servo Trim to the neutral position.
•Adjust the idling adjusting screw on the Carburetor
to be open approx. 1mm gap.

Idling adjusting
Screw

•Adjust both of the 10300 Engine Control and Brake
linkage accordingly.

•Adjust the Engine while it is not running.

•Adjust the Servo-Horn mounting position for the
carburetor to be full open.
•Change the pivot mounting position on the servo
horn in case the Carburetor is not opening fully or
if it is opening excessively. Or if available on the
transmitter, adjust the Throttle high end point.

•Adjust 10300 so the brakes work smoothly.
if the brakes apply too much or not enough,
adjust 36140 accordingly. Or if available on the
transmitter, adjust the High-End Brake adjustment.
•Adjust 36140 to Change the front or Rear Brake.

36140

10300

0.5mm

Approx. 0.5mm

Carburetor is
Opening fully

10300

Use the screw
provided with
your servo.

3x3mm

10300

10769