Assembly of the manifold and muffler – OFNA Racing Ravager User Manual

Page 25

1114
3mm Hex Screw
for Engine Mount

40047
Fuel Tank
Post
( Front )

40047
Fuel Tank
Post
( Rear )

* Take the fuel tank post
from J-42 plastic parts tree.

3x3mm
Set Screw

40050
Muffler Stay
Post

40051
Muffler
Stay

INSTALLATION OF THE FUEL TANK
AND ENGINE ONTO CHASSIS

3X15mm
Tapping Screw

40066
Pressure
Nipple

40066
Fuel Tank

40066
Fuel Nipple

3x10mm
Tapping Screw

ASSEMBLY OF THE MANIFOLD AND
MUFFLER

* Read this page very carefully.

4x10mm
Flat Head
Screw

5x5mm or 4x4mm
Set Screw

* Tighten the strip
and cut off the excess.

* Drill a hole (Size 3.5mm)
in the place and align as shown.
Use a two part epoxy glue to
full seal the nipple base to the nipple.

3x20mm
Cap Screw

Note Book Paper

* Use note book paper to set
gear backlash between spur gear
and clutch bell.
If the space is not correct the spur gear
will be damaged.

Spur Gear

Clutch Bell

90 Degree

* Loose or tighten 3x20mm cap screw
and 5x10mm hex screw to align
spur gear and clutch bell gear to 90
degree.

* Assemble the fuel tank post
before assembling the fuel
nipple.

#10069
Manifold Adapter
( Red Silicone )

#31991
Manifold, Polished

#10120
Manifold
Spring

#10184
Blue, Silicone Tube

#10079
Alum. CNC
Pressure Nipple

#31992
Dual Chamber, Polished

40068

94003

94007

94033

94026