OFNA Racing Mutilator Pro RTR 32 - Manual (Page 22)

40127
40128
40127
3X8mm
Approx. 1mm gap
Carburetor is
Opening fully.
10300 Approx. 0.5mm
(Neutral) (Throttle High) (Brake)
Turn on the Transmitter then Receiver and set the
Engine Control Servo Trim to the neutral position.
Adjust the idling adjusting screw on the Carburetor
to be open approx. 1mm gap.
Idling Adjusting Screw
Adjust both of the 10300 Engine Control and Brake
linkage accordingly.
Adjust the Engine while it is not running.
Adjust the Servo-Horn mounting position for the
Carburetor to be full open.
Change the pivot mounting position on the servo
horn in case the Carburetor is not opening fully or
if it is opening excessively. Or if available on the
Transmitter, adjust the Throttle high end point. Adjust 10300 so the brakes work smoothly.
If the brakes apply too much or not enough,
adjust 36140 accordingly. Or if available on the
Transmitter, adjust the High-End Brake
adjustment.
Adjust 36140 to Change the front or Rear Brake.
36140 Alum. Adjust Nut
.
40129
40076
40113
P10
Oil Seal
Be careful not to damage
shock shaft.
........X4
........X4
........X2
........X2 40090
2mm Washer
40090
1mm Washer
40090
3.5mm O-Ring
40556
2.6X5mm
Washer
40113
P10
Oil Seal
40059
40059
P14.7
O-Ring
Fit the o-ring into groove before
assembly.
40093
32033
UP
Down
Move slowly.
1. Pull down piston and pour oil
into shock cylinder.
fill the shocks
with oil.
2. To remove air bubbles by slowly
moving piston up and down.
3. Pull down piston, attach
pressure top and shock oil
overflow with tissue paper.
........X2 40060
M2.5 Nylon Nut
........X2
........X2
........X2
........X2
30403
6mm Ball End
4 090 0
4 9 00 0
2mm
090 40
1mm
4 09 0 0
400 6 5
40054
400 0 6
40098
4 0 8 0 9
Shock Piston
k (Blac )
0403 3
40090
7mm R-Ring ........X2
Builds two front shocks.
39 ADJUSTING THE ENGINE CONTROL LINKAGES
10300
Spring
Compress
40 ASSEMBLY OF THE AIR FILTER
........X1 94002
3X8mm
Hex Screw
40128
ZIP TIES
41 ASSEMBLY OF THE FRONT SHOCK
2.6 5mm X
2.6X5mm
*Apply filter oil to the
foam before use.
17
Step 1 Step 2
Step 1 Step 2
Do Not
Over Tighten