Wilbur Curtis CBP - Manual (Page 2)

2
Program Menus
Tea Recipes
Program Menus
Continued on Page 3
Brewing Instructions – Tea
1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button) and Ready-to-Brew displayed.
2. Make sure deck is folded down and tea container is in place.
3. Place filter in
brew basket.
Pour tea into
basket marked
ICED TEA.
4. Slide brew
cone into rails.
Place tea
container under
brew cone.
Programming
Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button 4 (green) and then press and release ON/OFF button (yellow).
Continue holding BREW button. Display will read
, wait until is displayed Enter the 4-digit access code, the digits 1-4 corre-
spond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then
will be displayed.
Your Curtis G3/Gold Cup Series is Factory Pre-Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the
controller.
The control displays
. Press ON/OFF button and the screen will display . After three seconds,
is displayed.
The the heating tank will fill in approximately two to three minutes, depending on water flow rate.
When the proper level is reached will appear on the screen. It takes approximately 20 minutes to reach set point tem-
perature of 204°F.
Control will display when temperature reaches the set point (204°F). Unit is now ready to brew.
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
 SELECTION or ENTER to save new parameter
Scroll RIGHT
4 3 1 2
Selecting Brew by Volume or Brew by Time depends on whether you know your brew time before starting.
From Program Menus press > display will now show the next feature.
Tea Recipes (Factory setting, Standard – Purple Full, Standard – Purple Half)
Press  to Select. Press < or > to toggle between Standard-Gray, Standard-Purple, Tropical-Gray, Tropical-
Purple, 76/308-Gray and 76/308-Purple. Set and exit programming by pressing .
SPRAYHEADS: Mentioned in this Programming guide are the words Gray and Purple. This
refers to the color of the sprayhead. The current sprayhead is the purple AFS. The older
version is the gray sprayhead. See the illustration at right.
PURPLE
GRAY
5. Press the
tea brew
button to begin
brewing tea.