Zigen HDBaseT Switches - Manual (Page 66)

Matrix Switcher Series—User Manual
65
Appendix B IR Mini-Controller
The Matrix Switcher supports an IR Mini-Controller to allow you to select input channel
through infrared sensor upon an extended connection
– Extender (HX-RW). The signal
for IR Mini-Controller is only available to the IR Receiver Cable connected to the IR1 IN
or IR2 IN IR receiver of Extender (HVX-100-R). If there are over 2 IR Receivers receive
the signal, all of them will be switched to the same selected input simultaneously. In
order to avoid the event occurs described above, you can configure the positions of
your IR Receivers based on different environments. The IR Mini-Controller is optional.
 0~9 keys are used for channel selection.
 And keys are used to increase or decrease channel. Is specified to decrease
channel, alternately, is specified to increase channel. For example, press  keys to
add increased 1 channel to channel16; it will go back to channel 1. Otherwise, if you
are in channel 1, you can press key to go to channel 16.
 Press Power key to switch to “0” (OFF).
 Other keys are useless.
 For channel configurations, e.g. channel 1, you can press
“1” key and wait about 3
seconds, alternately, you can also press
“01” keys to switch channel directly.