3 connect matrix switcher and pc, 2 matrix configuration – Zigen HDBaseT Switches User Manual
Page 33
Matrix Switcher Series—User Manual
32
7.1.3 Connect Matrix Switcher and PC
You must power off the Matrix Switcher. Then, connect the Matrix RS-232 port to the PC
RS-232 port with the bundled communication cable. And make sure the DIPs on the rear
panel are set to Master and RS-232. (Refer to the previous section
7.2 Matrix Configuration
After finishing installation, click
to active AV Matrix Application. In the
“Options” window, select the connected PC Port number and Baud rate, and then click
“OK”.
Figure 7-2 AV Matrix Options Window
The software controls signal connection between the corresponding input port and
output port as required. The AV Matrix software application main window is shown as
below:
Figure 7-3《AV Matrix》Software Application Main Window