Zigen HDBaseT Switches - Manual (Page 12)

Matrix Switcher Series—User Manual
11
 OUT1~4, 8 or 16 keys (output channel): Specify the Channel 1~Channel 4, 8 or 16 for
HDMI signal output. These keys configure the status or access the settings; you can
also use these keys to switch output channels.
 IN1~4, 8 or 16 keys (input channel): Specify the Channel 1~Channel 4, 8 or 16 for
HDMI signal input. Use these keys to switch the connected input channels or use them
to instead of number keys upon memory selections.
 ALL: This key allows user to set single input channel to all output channels. The usage
of “ALL” key is the same as output key.
- Press the “ALL” key.
- Select the one of the IN 1~4, 8 or 16 keys.
- The selected IN x key will transfer the input signal to all output channels.
- You can also press the “ALL” key and then press the “OFF” key to disable all
the displayed switching settings.
 OFF: Disable the entire output channels. Press one of the OUT x keys that want to be
disabled for the output channel, then press the
“OFF” key. Likewise, press the “ALL”
key and then press the
“OFF” key to disable all the displayed switching settings. In
addition to switching port menu, press
“OFF” key can return to the main screen during
implementing in other menu. You can also press
“OFF” key to disable the light of LCD
screen for saving power.
 EDID: FIX (fix mode) and OUT1 (access the first output channel) selection key.
- FIX mode: The Matrix Switcher supplies a set of fixed EDID values to support up
to only 1080P high performance TV.
- OUT1 mode: The Matrix Switcher will access the EDID values of high
performance TV that connected to the first output channel, and copy the EDID
value to all the input channels so that the DVD player can support to all the
HDTV.
 RETURN: Press this key to go back to main screen.
 PLUG: Press this key to show you the status of all HDMI Type A or RJ45 jacks on the
rear panel. If the HDMI or RJ45 jack is in HPD (hot plug detect), it will appear “O” on
the screen. Alternatively, it will appear “X” specified the HDMI or RJ45 jack is unused.
 INFO: Press this key to show you the Matrix Switcher ’s version, ID and IP address.
 Press PLUG and INFO keys simultaneously to show you the firmware versions of
modules.
 STO: The “Store Key” saves all current output/input corresponding relations up to 8
sets for a memory control.