Zigen HDBaseT Switches User Manual
Page 15
Matrix Switcher Series—User Manual
14
The HX-1616 supports up to 16 input jacks (HDMI Type A) and 16 output jacks (RJ45)
on the rear panel, each female terminals form the signal input/output jacks. The HX-1616
signal input/output terminal channels are numbered as IN1~16/OUT1~16 channels. The
input terminal channels supply you to connect to different equipment including
Blu-ray/DVD players, graphics workstations, and number displays. The output jacks
allow you to connect to extensible accessory devices for over long connections with
terminals just like projectors, video recorders, displays and multiplexers and so on.
Power Port: The Power Port is applicable for 100~240VAC, 50~60Hz connected to the
outlet of power source. Refer to
Power Switch: To switch power ON or OFF the Matrix Switcher.
RS-232: Use a 9-pin RS-232 cable to connect both computer serial port (COM1 or
COM2) and Matrix Switcher RS-232 communication port, refer to
The
computer then can be deployed to control the Matrix Switcher after installing of
application software. Refer to
Appendix D RS-232 Communication Protocol
for an individual configuration.
RS-485: Connection ports allow you to connect/control more than one Matrix product,
refer to
LAN Port: Use the RJ45 connection cable to connect the Internet and the Matrix
Switcher. The entire PCs at the same network can control the Matrix Switcher through
Switchers: Matrix Switcher supports 8 pins DIP and 2 pins DIP switchers for
connected configurations. For more information, refer to
- Pin 1~Pin5: ID
- Pin 6: Master/Slave
- Pin 7: RS-232/LAN
- Pin 8: IP RESET
IR EXT: This is used to connect the IR Receiver Cable for the Matrix Switcher Remote
Controller. Refer to
INPUT1~4, 8 or 16: Matrix Switcher Input jacks are connected to the Blu-ray players,
DVD players, STBs or other source devices.
HDMI Type A: Pin Definitions:
Pin #
Signal
Pin #
Signal
1
TMDS Data2+
11
TMDS Clock Shield
2
TMDS Data2 Shield
12
TMDS Clock-
3
TMDS Data2-
13
CEC (NC on device)