Outdoor Great Room Patio Pergola - Manual (Page 5)

Installation Of Ledger Board
Note: It is strongly recommended that the ledger board be installed
by experienced contractor to insure solid and water-tight fit.
1. Make sure there are no obstructions to interfere with assembled
unit (See dimensions)
2. Mount ledger board at correct height.
NOTE: Different home exteriors will require a variety of hardware
(wood siding, metal or vinyl siding, stucco, brick). Consult a qualified
installer for correct hardware to use. Make sure ledger is level.
3. Attach 2 beam hanger brackets (not included) .
4. Caulk and seal ledger board as necessary.
Drip-cap flashing may be required on
some installations (not supplied with per-
gola)
Ledger board bolts to house. Locate
studs to permit lag bolts to screw into
studs. Use masonry anchor bolts on brick
Lag bolts (Minimum 6) furnished
by installer.
Beam hanger brackets (2) furnished
D
Attached with lag
bolts to wall
Note:
Cleat strip may need to be trimmed back to
accommodate beam hanger brackets. Use
finishing saw if necessary.
Cleat Strip