Dell PowerVault 715N (Rackmount NAS Appliance) - Manual (Page 10)

Non-Dell Rack Requirements
Q)
NOTICE: This VersaRails rack kit is intended to be instaiied by trained service technicians in a
rack that meets the specifications of American Nationai Standards Institute (ANSD/Eiectronic
Industries Association (EIA) standard ANSI/EIA-310-D-92, International Electrotechnical
Commission (IEC) 297, and Deutsche Industrie Norm (DIN) 41494. One rack kit is required for
each system that is installed in a rack.
Before You Begin
Before you begin installing your system in the гаек, earefully read "Safety Instruetions,"
found earlier in this guide, as well as the safety instruetions found in your system’s
System
Information doeument for additional information.
CAUTION: When installing multiple systems in a rack, complete all of the
procedures for the current system before attempting to install the next system.
^ NOTE: For instructions on installing the system itself, see "Installing a System in the Rack."
Important Safety Information
Observe the safety preeautions in the following subseetions when installing your system in
the raek.
CAUTION: You must strictly follow the procedures in this document to protect
yourself as well as others who may be involved. Your system may be large and
heavy and proper preparation and planning are important to prevent injury to
yourself and to others. This becomes increasingly important when systems are
installed high up in the rack.
Rack Stabilizer Feet
CAUTION: Installing systems in a rack without the front and side stabilizer feet
installed and anchored to the floor could cause the rack to tip over, potentially
resulting in bodily injury under certain circumstances. Therefore, always install
and anchor the stabilizer feet before installing components in the rack.
CAUTION: After installing systems in a rack, never pull more than one system
out of the rack on its slide assemblies at one time. The weight of more than one
extended system could cause the rack to tip over and cause injury.
The stabilizer feet help prevent the raek from tipping over when a system or other
eomponent is pulled out of the raek with the slide assemblies fully extended. Refer to the
doeumentation provided with the raek eabinet for instruetions on installing and anehoring
the stabilizer feet.
1 - 6 I R a c k I n s t a l l a t i o n G u i d e