Workrite Poise–Dual - Manual (Page 7)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 7
Workrite Poise–Dual™ Installation Instructions
7
6
Adjustment for Tilt Action
If the monitor doesn’t hold its tilt position or
is too hard to tilt, adjust the screw directly
behind the LCD screen with the M5 Allen
wrench provided (clockwise to tighten,
counter-clockwise to loosen).
If your monitor is too light or too heavy for the factory-set tension,
the arm will raise or lower too easily (or even on its own). If this is the
case, you need to adjust the vertical movement.
Set the monitor arm at a 90° angle and locate the adjustment screw on
the top of the arm joint.
If the arm tends to rise, turn the adjustment screw clockwise using the
M5 hex wrench, decreasing tension until the arm reaches a stable, bal-
anced adjustment.
If the arm tends to drop, turn the adjustment screw counterclockwise
using the M5 hex wrench, increasing tension until the arm reaches a
stable, balanced adjustment. With too much tension on the arm, the
arm will tend to rise.
Vertical Movement Adjustment
a
b
c
Loosen
Tighten
Tension
screw
90°
To prevent damage to the arm,
remove the hex wrench after
adjustment.
Adjustment
Screw
a
b
c