Workrite Non-VESA Monitor Mount - Manual

#1500194 - Rev A
Instructions
Non-VESA Monitor Mount
A
Base Plate
Qty: 1
B
Left Clamp Arm
Qty: 1
C
Right Clamp Arm
Qty: 1
D
Top Clamp Arm
Qty: 1
Parts
E
#10 Nylon Washer
(white)
Qty: 5
F
#10/32 Knob
Qty: 1
G
#10 Flat Washer
(black)
Qty: 6
H
#10–32 Nyloc Hex
Nut
Qty: 5
I
#8×.25 Nylon Spacer
Qty: 4
J
#8 Keps Nut (black)
Qty: 4
K
#8–32×.75 Pan Head
Philips Screw
Qty: 4
Place Base Plate in the center and Clamp Arms around the bottom corners of your
monitor. Remember, with your monitor upside down, the right side is on the left
and vice versa.
Place the Base Plate in the center of the
back of the monitor to align the Base Plate
with the Clamp Arms.
Place the Left Clamp Arm around the
bottom left monitor corner and the Right
Clamp Arm around the bottom right
corner of your monitor. You’ll need to lift
the bottom corners to “wrap” the clamps
around the bottom corners.
Slide the Clamp Arms to make sure you
have a snug fit. Securely attach the Base
Plate to the two Clamp Arms using #10
Nylon Washer (white) (E), #10 Flat Washer
(black) (G) and #10 Nyloc Hex Nut (H).
Lay your monitor face down on a clean, soft worksurface.
Make sure your worksurface is clean and will not
damage your monitor. Having a soft surface will aid in
protecting your monitor while the hardware is being
attached.
b
b
a
1
a
b
c
2
c E
H
G