Workrite SwingArm - Manual

Workrite Ergonomics | 800.959.9675 www.workriteergo.com
#1500131 - Rev C
E
Wall Mount
Qty: 1
Parts
Assembly Instructions
for Workrite Poise™
and SwingArm™
Sierra Tool Bar Mount
Attach Wall Mount to Tool Bar Mounting Bracket
Attach Wall Mount to Tool Bar Mounting Bracket with four screws, using a Phillips-head
screwdriver (not included). Keep cushion that comes with Wall Mount for Step 2.
1
a
Verify that you have all the hardware needed for the assembly.
Note! Please read this if you
are remounting a previously
installed Workrite Poise or
SwingArm.
A
Tool Bar Mounting Bracket
Qty: 1
B
Tool Bar Mounting Plate
Qty: 1
E
a
A
If converting from
desktop unit, order
SAWALL separately
Phillips-head screwdriver
D
Cushion
Qty: 1
To change an existing desk or wall-mounted Workrite Poise or
SwingArm installation into one that connects to the Sierra Tool Bar,
you must first remove the Workrite Poise or SwingArm from its
current mount:
Loosen set screw in back of base near top of current desk mount.
Remove plastic cap from top of Arm Assembly by popping it off.
Loosen screw holding arm to mount with an M5 Allen Wrench. Carefully remove monitor and
arm from existing mount. Set aside in safe location until Tool Bar Mount assembly is complete.
C
M8 x 14mm Screws
Qty: 2
Workrite Poise or SwingArm
(sold separately)
Wor
krit
e P
oise™
Workrite Poise
™