Workrite Willow Dual Upgrade Instructions - Manual

#1500184 - Rev B
Important Safety Instructions
Read and understand all these safety instructions before using the product.
Do not mount the Desk Base of the Willow Arm on an unstable surface or any surface that could not mount the Desk
Base firmly.
During installation, beware of the recoil of the Willow Arm body when attaching or detaching the monitor to the Willow
Arm. To prevent damage or injury when changing the monitor, always raise the Arm to its highest position before the
monitor is detached. The Willow Arm can support monitors from 1 to 14 pounds.
Do not attempt to disassemble, service or modify the product.
Use only a slightly damp cloth to clean the Willow Arm surface. Never use flammable solvents like alcohol, benzene,
thinner, etc. on the product.
Willow
TM
Dual Upgrade Instructions
A
Willow Arm Assembly
Qty: 1
B
Quick Release
Bracket
Qty: 1
C
M4x18 Phillips
Screws
Qty: 4
F
10mm Plastic
Spacers
Qty: 4
Parts grouped by package
D
M4x12 Phillips
Screws
Qty: 4
E
M4x8 Phillips
Screws
Qty: 4
G
3/16" Allen
Wrench
Qty: 1
M8 Flat Head Cap Screw M4 8mm Screw M4 12mm Screw M4 16mm Screw Spacer
Plastic Cap 7/32” Allen Wrench 1/8” Allen Wrench
Button Head Allen Cap Screw Pivot Pin
Steel Washer Plastic Pivot Washer
M8 Flat Head Cap Screw M4 8mm Screw M4 12mm Screw M4 16mm Screw Spacer
Plastic Cap 7/32” Allen Wrench 1/8” Allen Wrench
Button Head Allen Cap Screw Pivot Pin
Steel Washer Plastic Pivot Washer
M8 Flat Head Cap Screw M4 8mm Screw M4 12mm Screw M4 16mm Screw Spacer
Plastic Cap 7/32” Allen Wrench 1/8” Allen Wrench
Button Head Allen Cap Screw Pivot Pin
Steel Washer Plastic Pivot Washer
M8 Flat Head Cap Screw M4 8mm Screw M4 12mm Screw M4 16mm Screw Spacer
Plastic Cap 7/32” Allen Wrench 1/8” Allen Wrench
Button Head Allen Cap Screw Pivot Pin
Steel Washer Plastic Pivot Washer
M8 Flat Head Cap Screw M4 8mm Screw M4 12mm Screw M4 16mm Screw Spacer
Plastic Cap 7/32” Allen Wrench 1/8” Allen Wrench
Button Head Allen Cap Screw Pivot Pin
Steel Washer Plastic Pivot Washer
Verify that you have all the hardware and tools needed
for the assembly
Check your packages against the parts list to verify that you
have all the parts needed.
You will also need the following tools:
9 /
16
" end wrench or socket
⅝" end wrench or socket
½" end wrench or socket
I
5/16" x 18 x
1¾" Hex Bolt
Qty: 1
K
Metal
Washer
Qty: 1
L
Plastic Washer
Qty: 1
M
Steel Cup
Qty: 1
N
Pivot
Bushing
Qty: 1
J
⅜"x16
Lock Nut
Qty: 2
O
Plastic
Spacer
Qty: 1
H
Pivot Cover Cap
Qty: 1