Workrite Poise–Dual - Manual (Page 4)

4 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Poise–Dual™ Installation Instructions
1
Verify that you have all the hardware and tools needed for the assembly
Check your cartons against the list on page 2 to verify that you have all the parts needed.
You will also need the following tools:
#3 tip Phillips screwdriver
2
For Grommet Base please skip to Step 3.
Attach the base cushion to the underside of the
base.
Attach 14” pole to base, securely tighten 4 set
screws (already in place).
Attach the clamping bracket to worksurface with 2
button-head cap screws. (See note below.) Use the
upper set of holes on the bracket for work surfaces
between ½" and 1¼" thick, and use the lower set for
work surfaces between 1¼" and 2¼" thick.
Tighten the clamping bracket until it is firmly
clamped to the work
surface.
Skip to step 4.
If there is not enough clearance to fit the assembled base between
the back of the worksurface and the wall, place the clamp base on the
desk edge before attaching the clamping bracket from below.
C
B
E
F
a
b
c
d
a
b
c
d
A
Clamp Base Only: Attach Clamp Base to Worksurface
M