Workrite Poise–Dual User Manual

Page 5

Workrite Ergonomics | 800.959.9675 www.workriteergo.com

Workrite Poise–Dual™ Installation Instructions

Attach Monitor Arms to Monitors

Place monitor carefully on a clean, flat

surface, face down.

Attach the monitor arm to the back of the

monitor with four screws, using a Phillips-

head screwdriver (not included). Use the

mounting screws provided by your moni-

tor manufacturer if available. Otherwise,

use the screws provided that best fits

your monitor.

Use the outer holes for a

100mm mount, or the inner holdes for a

75mm mount.

Repeat for the second monitor.

X or Y

Remove the center hole from the base cush-

ion, then attach it to the underside of the base,

aligning the hole in the base with the hole in the

protector. Thread the M8 Thread Rod into the

bottom of the base.

Attach 14” pole to base, securely tighten 4 set

screws (already in place).

Place the base on the work surface, centering it

over a bolting hole from 3/8” to 3” in diameter.

Position the U-Bracket and Small Washer onto

the M8 Thread Rod and secure the bracket by

tightening the Wing Nut.

Proceed to step 4.

Grommet Base Only: Attach Grommet Base to Work Surface