Workrite Sierra Assembly Instructions for 3-leg Workcenters - Manual (Page 5)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5
Sierra Series Workcenters - Assembly Instructions for 2 and 3-leg Tables
6
Attach Control Box to Tabletop
If you do not have a Workrite tabletop:
Place Control Box in position and use a pencil to mark pilot hole placement. Control box should
be placed towards rear center of tabletop. Be sure to place a mark in the small part of Mounting
Flange’s keyhole opening. Remove Control Box and drill pilot holes where marked.
With Control Box positioned over pilot holes, attach one #8 x ⅝" Mounting Screw through the
Mounting Flange’s opening.
Attach another #8 x ⅝" Mounting Screw through Mounting Hole at back right of Control Box.
5
a
M1
M2
M3
Mounting Flange
G
H
a
b
b
H
Attach Cable Spools and Velcro Tabs
Attach cable spools and Velcro ® tabs to underside of tabletop as indicated in instructions contained
within Cable Management Kit. If you do NOT have a Workrite tabletop, mount cable spools in a
convenient location between legs and control box.
Refer to instructions in Cable Management Kit.
K
If you have a 3-leg table,
mount Control Box on
same side of tabletop as
switch to allow switch
cord to reach Control Box.
Mounting Hole