Workrite Sierra Assembly Instructions for 3-leg Workcenters User Manual
Page 12

12
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sierra Series Workcenters - Assembly Instructions for 2 and 3-leg Tables
3
4
Adjust Starting Digital Height Readout
(Use if you have a worksurface that is not 1⅛" thick, causing inaccurate readout of the lowest
height)
Lower the table to the lowest position and measure the height from the floor to the top of the
worksurface. (not shown)
Press the “SET” button with a ballpoint pen (
Do NOT use a paperclip - it may damage the electronics
).
Press and hold “Down” button until display flashes.
Press “Up” or “Down” button until display shows actual measured height for the worksurface.
Press the “SET” button with a ballpoint pen (
NOT a paperclip
).
Note: Height readout must be readjusted separately for inches and centimeters.
Table Locking Feature
To Lock:
Press and hold the “SET” button with a ballpoint pen until the control box clicks two times –
The table will now be locked and will not move when any buttons are pushed. A padlock icon will
appear on the display when the table is locked.
To Unlock:
Press 1, then 2 and then 3 to unlock. *The default unlock code is always 1-2-3.
a
b
or +
2
3
1
5
10
15
20
25
30
35
40
45
50
55
60
a
b
c
d
e
or +
2
3
1
5
10
15
20
25
30
35
40
45
50
55
60
b
c
d
e
a
b