Wine Guardian Ducted Wine Cellar Cooling Systems (WG175) - Manual - Manual (Page 41)

37
3. Drill two (2) .32cm holes and insert anchors
(provided) within the mounting surface. Anchors may
not be required if securing to a wall stud or racking
system. 钻两个（
2）0.32 厘米的洞，并在安装表面插
入钉锚（提供件）。如果控制器背板安装在木制的墙
或框货架系统，钉锚可能不需要。
4. Plug in the communication cable to the back of
the Remote Interface Controller backing plate. (Fig.4) 将
通信电缆插入遥控控制器接口板背面的插头。 （图
4）
a) Attach backing plate to wall using the two
screws provided with the system. (Fig.5) ) 用提供的两
个螺丝将接口板背面垫板装到墙上。 （图 5）
5. Re-install plastic face plate on to backing plate.
将正面的盖板盖好。
6. Re-attach the communication cable to the side of
the Wine Guardian cooling unit. (Fig.6) 将通信电
缆插回酒卫主机的侧面（图 6）
Fig. 4
Fig. 5
Fig. 6
Fig. 5