Welch Allyn 5091-48 Mobile Stand Conversion Kit, Aneroid Instructions - Installation Guide User Manual
Welch allyn, inc
Tools Required:
Phillips screwdriver
5/16 open / box wrench
5/16 open / box wrench
1.
Disassemble mobile or wall mounted manometer from old bracket.
2.
Assemble new bracket to manometer. Use two (2) 1/2 inch long screws with nuts as shown.
3.
Insert bearing and bushing into bracket.
4.
Assemble manometer and bracket to basket. Use the (3) 3/8 inch long screws and nuts provided.
5.
To complete the mobile stand assembly, refer to the new instruction booklet provided.
Welch Allyn, Inc.
4341 State Street Road
Skaneateles Falls, NY 13153 USA
95P324 Rev. B
5091-48
Mobile Stand Conversion Kit
Aneroid Instructions
Tools Required:
Phillips screwdriver
5/16 open / box wrench
5/16 open / box wrench
1.
Disassemble mobile or wall mounted manometer from old bracket.
2.
Assemble new bracket to manometer. Use two (2) 1/2 inch long screws with nuts as shown.
3.
Insert bearing and bushing into bracket.
4.
Assemble manometer and bracket to basket. Use the (3) 3/8 inch long screws and nuts provided.
5.
To complete the mobile stand assembly, refer to the new instruction booklet provided.
Welch Allyn, Inc.
4341 State Street Road
Skaneateles Falls, NY 13153 USA
95P324 Rev. B
5091-48
Mobile Stand Conversion Kit
Aneroid Instructions
Document Outline
- 5091-48
- Mobile Stand Conversion Kit
- Aneroid Instructions
- 1. Disassemble mobile or wall mounted manometer from old bracket.
- 2. Assemble new bracket to manometer. Use two (2) 1/2 inch long screws with nuts as shown.
- 3. Insert bearing and bushing into bracket.
- 4. Assemble manometer and bracket to basket. Use the (3) 3/8 inch long screws and nuts provided.
- 5. To complete the mobile stand assembly, refer to the new instruction booklet provided.
- Welch Allyn, Inc.
- 4341 State Street Road
- Skaneateles Falls, NY 13153 USA
- 5091-48
- Mobile Stand Conversion Kit
- Aneroid Instructions
- 1. Disassemble mobile or wall mounted manometer from old bracket.
- 2. Assemble new bracket to manometer. Use two (2) 1/2 inch long screws with nuts as shown.
- 3. Insert bearing and bushing into bracket.
- 4. Assemble manometer and bracket to basket. Use the (3) 3/8 inch long screws and nuts provided.
- 5. To complete the mobile stand assembly, refer to the new instruction booklet provided.
- Welch Allyn, Inc.