Welch Allyn Solarc Light Source - User Manual - Manual (Page 15)

13
3
Maintenance
This section provides information to replace a lamp and to
clean the Light Source. There are no other serviceable parts
within the Light Source.
Lamp Replacement
To replace the lamp:
1. Turn the Solarc Light Source off and unplug the power
cord from both the wall outlet and the rear of the unit.
WARNING RISK OF SHOCK. Do not
operate the Light Source without a lamp
installed. Disconnect power before
attempting to change lamp.
Caution LAMP MAY BE HOT. Allow lamp to
cool before handling.
Recommended lamp cooling time is a minimum
of 10 minutes.
Caution Do not operate device without the
cover in place. Operate in the horizontal position
only.